スポンサーサイト
上記の広告は1ヶ月以上更新のないブログに表示されています。
新しい記事を書く事で広告が消せます。


スポンサー広告 | --:--:-- | Trackback(-) | Comments(-)
03 Split
Exciteで和訳する(参考)

In a proper architectural drawing, the joins between the inside walls and the outside walls are drawn open.

split12-2.jpg

Use the Split option to create these gaps. Select the Split tool from the third row of the righthand column in the toolbox using the pop-up menu. It is at the bottom left of the pop-up menu that opens.

split12-2.jpg

Click the top line of the horizontal inside wall so that it is highlighted red. Next click the inside line of the adjoining outer wall.

split12-2.jpg

CADintosh marks the point with a small cross. The line will be broken at the point marked with the cross. You cannot see a gap, however, because the two parts meet each other. We will reach our aim by deleting the part under the cross with the trim option. Select the trim option for sharp corners in the toolbox.

split12-2.jpg

Click the bottom line of the inside wall as it will be the "knife", i.e. the reference object. Then click the vertical line under the inside wall. The small part above the corner point will be deleted.

split12-2.jpg

The walls are now joined completely. If you want to remove the red marking of the reference line, press Escape. Repeat the break and trim process on the right-hand outside wall to practice.

You can break the two other points at the top and bottom on the small inside wall in one action.

Select the Split tool again and click the right-hand line of the vertical inside wall so that it is highlighted in red. Click the bottom line of the horizontal inside wall to the right of the vertical wall and also the inside line of the outer wall. The points where the lines have been split are indicated with a small cross.

split12-2.jpg

Select the trim option for sharp corners in the toolbox again.

split12-2.jpg

Click the left-hand line of the vertical wall as a “knife” and click the adjoining lines of the inside and outside wall to the left of the line highlighted in red.

split12-2.jpg

>> 04 A Door
スポンサーサイト


CADintosh入門 | 11:20:24 | Trackback(0) | Comments(-)


Search
Search this site.
Calender
- - - - 1 2 3
4 5 6 7 8 9 10
11 12 13 14 15 16 17
18 19 20 21 22 23 24
25 26 27 28 29 30 -
05月 « 2017/06 » 07月
Recent Comments
Recent Trackbacks
Profile+Misc.

  • author: Makoto Inoue
  • 日本語ローカライズ担当




上記広告は1ヶ月以上更新のないブログに表示されています。新しい記事を書くことで広告を消せます。